Origami crane

Step 1. Start with a square piece of paper, coloured side up.

Fold the top corner of the paper down to the bottom corner. Crease and open again. Then wrap the left corner of the paper and align it with the right corner. Unfold the paper.

 

Step 2. Turn the paper over to the white side.

Fold the paper in half, crease and open, and then fold again in the other direction.

 

 

3. Using the creases you have made, bring the top, left and right corners of the model down to the bottom corner. Well flatten model.

 

Step 4. Fold topleft, right corners into the centre and unfold them.

 

 

Step 5. Fold top corner of model downwards, crease and unfold.

Step 6. Open the uppermost flap of the model, bringing it upwards and pressing the sides of the model inwards at the same time. Flatten down, creasing well.

Step 7. Turn model over and repeat Steps 4-6 on this side.

 

 

 

Step 8. Fold top left and right flaps into the centre.

 

 

 

Step 9. Turn model over and repeat on other side.

 

 

 

Step 10. Fold both ‘legs’ of model up at a slight angle, crease very well, then unfold.

Step 11. Fold the “legs” inside along the creases you just made.

 

Step 12. Fold one side of theĀ “leg” to make a head, then fold down the wings.

 

 

And you have finished the crane!

Leave a Reply

Your email address will not be published. Required fields are marked *